06-05-2009, 05:40 PM
I had to change the Comfort 1 board on a commercial job, the power supply side failed, but it appeared to be all working fine on battery.
The replacement Board, from Andrew at Comfort Home Controls had a 4.207 processor and file system 18. I changed ALL the plug in chips from the old board and installed them on the new one, so it now had a Version 4.225 Processor. I uploaded ââ¬ËSystem Informationââ¬â¢ and it said it now had File system 24, which I was using. Everything seemed as before, except there is now a different voice and some of the names are no longer announced as they were written.
I downloaded the comfort file and all appeared to be working apart from some of the responses, which either do not work or switch the wrong output. Also it does not auto arm within a response anymore, although arming on the keypad works fine.
The system controls lights, roller shutter Urinal flushing, water heating etc. All these appear to be working as usual and the time programs, via a response also works. The ones I seem to be having trouble with seem to be the ones which contain ââ¬ËFlagsââ¬â¢, although there are others not working.
Can anyone give any tips as to what may be corrupting the file and responses? Should I put all the new chips back on the board and convert the file from 24 to File system 18?
Many Thanks Graham
The replacement Board, from Andrew at Comfort Home Controls had a 4.207 processor and file system 18. I changed ALL the plug in chips from the old board and installed them on the new one, so it now had a Version 4.225 Processor. I uploaded ââ¬ËSystem Informationââ¬â¢ and it said it now had File system 24, which I was using. Everything seemed as before, except there is now a different voice and some of the names are no longer announced as they were written.
I downloaded the comfort file and all appeared to be working apart from some of the responses, which either do not work or switch the wrong output. Also it does not auto arm within a response anymore, although arming on the keypad works fine.
The system controls lights, roller shutter Urinal flushing, water heating etc. All these appear to be working as usual and the time programs, via a response also works. The ones I seem to be having trouble with seem to be the ones which contain ââ¬ËFlagsââ¬â¢, although there are others not working.
Can anyone give any tips as to what may be corrupting the file and responses? Should I put all the new chips back on the board and convert the file from 24 to File system 18?
Many Thanks Graham