Comfort Automation/ Security System Forums

I have just noticed a very concerning bug in V3.0.1. I am using a UCM dynalite which has been working for 2 years now. When i open a response that is using a Linear preset command i.e Dynalite LinearPreset 2 17 3 0 255, every time a reopen it it adds 1 to the preset number. the above response should be Dynalite LinearPreset 2 17 1 0 255. it is doing this to commands from v2.3 and also if a add a new command to the response. I will look thru some of the other dynalite commands when i have time.
Thanks

I have tested this a little bit and in the attached program there are 2 dynalite responses that are buggy, DT2 and DT3. DT2 adds 1 to the preset value whenever the response is opened and i think when it is downloaded (offline so can\'t test). DT3 won\'t open without errors.
Thanks

Warby
Thanks for the report
The Issue with the Linear Preset being incremented was found and has been fixed for the new version, see Known issues in http://www.comfortforums.com/forum20/1446.html
We are looking at the Exception caused by DT3