Comfort Automation/ Security System Forums

Full Version: 2nd generation UCM/KNX Interface
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
Thats good. There were some minor bugs with 5.192 including the Read from Group Aggress that you reported. This has been fixed so you should upgrade to the new version
Chiu,

Just FYI...

The link you provide below is point to UCM05 latest firmware.

Comfort Firmware minimum = 5.164 but ULT 5.169 is the latest


So the Comfort firmware ULT5.169 is an official release?
The link is incorrect and will be corrected in the next few days. There is a problem with our servers currently


This topic shall be closed in order to prevent it from getting too long
Please post a new topic if you have any questions, comments or problems
Pages: 1 2