07-20-2009, 08:58 AM
Hello.
We upgraded the UCM/EIB Module with the KNX (Beta) firmware. All the hardware upgrades has been performed.
The KNX firmware upgrade has been succesfully performed.
When all the process finished, we restarted all modules and the PCB.
Then we restarted the Comfigurator v3.0.1.0. On the \"Modules\" tab, we made right click on \"UCM\'s\" and selected \"Scan for UCMs\" Option. Comfigurator didn\'t find any UCM (except the General with ID 1) connected, buy the module was connected to the bus.
If we try to add it manually, the KNX option is not available on the list shown by Comfigurator. The only option available is EIB.
How can we test the new features o KNX module? Do we need a beta version of Comfigurator Software?
We upgraded the UCM/EIB Module with the KNX (Beta) firmware. All the hardware upgrades has been performed.
The KNX firmware upgrade has been succesfully performed.
When all the process finished, we restarted all modules and the PCB.
Then we restarted the Comfigurator v3.0.1.0. On the \"Modules\" tab, we made right click on \"UCM\'s\" and selected \"Scan for UCMs\" Option. Comfigurator didn\'t find any UCM (except the General with ID 1) connected, buy the module was connected to the bus.
If we try to add it manually, the KNX option is not available on the list shown by Comfigurator. The only option available is EIB.
How can we test the new features o KNX module? Do we need a beta version of Comfigurator Software?