Comfort Automation/ Security System Forums

Hi All,

On my home system, after each power failure, I have to logon (via the keypad) to clear the power failure led and that creates the power restored event (at logon time). I thought the system should clear this when power is restored, without manual intervention.

Regards
Howser

As a security system, Comfort deliberately forces you to acknowledge that there was a power failure.

It may be important that there was not a power failure that occured which you did  not know of

So when will the power restore event run, at signon?

Howser, if you are referring to the red AC led on the keypad, then yes, the led will be cleared (turned off) when the power is restored.
I have just done a quick test on Comfort I firmware Action 4.233.

What is the firmware that you are having?

Hi Hendy,

I will check the version when I get home. I am talking about AC Restore Response (Location 1847), is that done as the AC is restored, or at signon ( if signon happens hours after AC restore)?

Regards
Howser

The AC Restore Response runs when the AC is restored