01-09-2011, 09:39 AM
I just added a UCM/232 to my system on ID 5 and did a \'Scan All UCM\'s\' from within Comfigurator.
The result was that the new UCM was picked up on ID #5 but it also set the Number of UCM\'s to 5 as well. This is incorrect as I have two existing UCM\'s on ID\'s 1 and 2 and now the third one on ID 5.
I couldn\'t find any documentation that stated that all UCM\'s must follow a numerical sequence from 1 onwards.
Can you please explain if this is indeed the case or if Comfigurator incorrectly assumes there are UCM\'s at ID\'s 3 & 4 which there aren\'t?
To fix this I have to manually set the number of UCM\'s from 5 down to 3.
Ingo
The result was that the new UCM was picked up on ID #5 but it also set the Number of UCM\'s to 5 as well. This is incorrect as I have two existing UCM\'s on ID\'s 1 and 2 and now the third one on ID 5.
I couldn\'t find any documentation that stated that all UCM\'s must follow a numerical sequence from 1 onwards.
Can you please explain if this is indeed the case or if Comfigurator incorrectly assumes there are UCM\'s at ID\'s 3 & 4 which there aren\'t?
To fix this I have to manually set the number of UCM\'s from 5 down to 3.
Ingo
