Comfort Automation/ Security System Forums

Hope someone can advice,

Brian (bs85) sent me his UCM/ethernet so I could get them both upgraded to latest 6.02 release.

My upgrade went straight in (though it took me a few mins to remember how to change IP address in tibo)...

I then swapped over to do Brians and noticed that his ethernet board does not have a notch in so I cannot insert the jumper to cover then 2 pins on PP2 to put it into programming mode....

Anyone got a quick easy solution for me so I can get it back in the post to him tomorrow?

Cheers

Stuart

The Ethernet daughterboard can unscrew easily, remove it, insert the jumper and plug the daughterboard back in. Once done you can reverse the procedure.

Ingo

Thanks all done!