10-06-2011, 02:27 AM
Pages: 1 2
10-07-2011, 04:39 AM
The Modules Tab > UCMs should show the Version numbers of all the UCMs instead of \"UNKNOWN\" as shown in your file (See screenshot below(
Do a Scan for Modules to get all the information in the screen before saving it. This will allow us to know what are the versions of the UCM/KNX and other versions
There are 3 possibilties;
Do a Scan for Modules to get all the information in the screen before saving it. This will allow us to know what are the versions of the UCM/KNX and other versions
There are 3 possibilties;
- The UCM/KNX firmware is too old and has some bugs. Upgrade the firmware to the latest 6.011
- You did not do Write to EEPROM after setting the counter for DesarmAlarmes
- The KNX group address 5/2/4 was not sent on the bus, to activate the counter response
10-12-2011, 01:19 PM
Hi Slychiu
I\'ve alredy solved the problem. I\'ve just upgraded the firmeware and it\'s working fine now.
By the way, thanks for the help.
I\'ve alredy solved the problem. I\'ve just upgraded the firmeware and it\'s working fine now.
By the way, thanks for the help.
Pages: 1 2