Comfort Automation/ Security System Forums

I have the LCD Keypad, with the standard demo config.
In Control - Lights I have managed to program the top two buttons with toggele
responses that operate outputs (Lighting the LEDs).

This was achieved using Control - 1 and 2.

I then attempted to program the Master OFF button on the control page.
I found that it is configured as 17 in the clipsal program.

Using the same technique in comfigurator I programmed the AllLightsTVOff response.

However when the button is pressed, the outputs are not changed.

My guess is that the response was assigned in the wrong counter. The group address in the program is in hexadecimal. Hence, it should not be in counter 17, but rather 23 (17 hex).

Thanks for the help. It worked.

\'more time needed in the manuals, I think\'