Map 1 bit Arm to Away to a group address seems not working.
Sending \"1\" from KNX bus to this group, does nothing in Comfort.
Can you check please?
Thanks.
This is the most commonly used function for KNX which should definately work
Can you send your cclx file to support@cytech.biz
No, thanks, i will investigate more.
Shure is my mistake.
Thank you.
Try updating the firmeware...it worked for me..
I seem to have the same problem after updating the firmware. Before it worked fine. Now I have all the modules last firmware and Comfort is sending time to KNX but Night Arming from KNX does not work.
Did you WRITE to EEPROM for the UCM/KNX?
We have confirmed that there is a bug in Comfort firmware 6.006, which causes the 1-bit arm from KNX not to work, see
http://www.comfortforums.com/forum79/2571.html
Please downgrade to ULT 6.005 for the time being
We are working on a new firmware release to fix this problem
We have found and fixed the bug in Comfort which causes the 1-bit arming not to work. Now we are doing intensive testing of the firmware which will take some time
The firmware ULT 6.009 is attached for those who would like to try it out for themselves before the release
See forum for Ultra beta firmware 6.009
http://www.comfortforums.com/forum79/2637.html