Comfort Automation/ Security System Forums

Hi,

I have a Comfort Ultra I Action 4.233.

I have four spare outputs on a RIO and I would like to use them for Status LEDs on the main panel (which is where the RIO is).  I connected 4 LEDs (with 2.0k resistors in series) and configured the outputs as status outputs in Comfigurator>Security>Status. 

After downloading the LEDs are constantly on and not representing the status correctly.

Any suggestions?

Thanks.

I am afraid you cannot use RIO outputs for indicating the onboard status leds with the current firmware
That function was done in the very old days and had a check on the output number of 64. It was not updated when the RIO/SCS was introduced. If you were to upgrade your firmware in future (for other reasons) this should have been implemented