Comfort Automation/ Security System Forums

I am using Comfort II 6.011 and UCM/KNX.
If I look at the Monitor Mode in Comfigurator I see KNX traffic, but Comfort does not send/receive any commands.
As soon I switch away from Monitor Mode (to \"KNX to Comfort\" for example) then communication works fine again.
Have you had the same problem?

Monitor Mode is for looking at received KNX telegrams only and normal operation is not supposed to work You have to exit moniotr mode for the receive telegrams to work

Please note a potential problem with monitor Mode in this post

http://www.comfortforums.com/view_topic.php?id=3286&forum_id=112&jump_to=14097#p14097

That link doesn\'t work IDENT.

Thanks it has been fixed IDENT