Comfort Automation/ Security System Forums

The UCM/Zwave manual has been amended to 2.09 which clarifies the repatetd use of Learn mode  is the same as replication

I am not entirley sure that answers the question. The two \"basic nodes\" appeared immediately after the creation process and before I reset the UCM device.

Okay, sometime in the next couple of days I will try to create a single virtual node using these updates instructions, record each step of the way, and report back.

Thanks again for all your help.

This evening I followed the instructions on creating a virtual node using the advice you gave me.
The node was successfully created.
Associations to the node were created and a response to it was added and saved to eeprom.
It worked.

A new association was added, and the response modified.
I attempted to save once again to eeprom.
Error: “Invalid data in EEPROM. Please Learn Again”
Using learn and \"inc\" the network was learned again.
BUT: The node reverted from \"virtual\" to \"basic\", AND NOW CANNOT BE USED.

If you can PM me an e-mail address I will send word document with screen prints and more detail.

Please send all info inclduing the cclx file to support@cytech.biz

Files sent