Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > ULTI > Any UCM/Ulti Firmware updates?
Full Version: Any UCM/Ulti Firmware updates?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Stub

10-19-2012, 05:21 PM
Is there any updated UCM/Ulti firmware that I should apply?

I can\'t see any listed explicitly here and I\'m unclear if I should be using the Universal UCM firmware or not?

According to Comfigurator I have UCM Type \"Ulti\" Version 6.008. Just been through the process of updating everything I can on my Comfort, so ETH02 to 6.024, Ultra II to 6.028.

ident

10-20-2012, 01:40 AM
There is no need to upgrade the firmware on UCM/Ulti
Do not use the Universal UCM firmware
The \"Ulti\" firmware  is really the same as  a normal UCM except that it talks to the Ulti wireless submodule
There are only a few commands for sending to ulti so there are no updates required since the list of commands has never changed
Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > ULTI > Any UCM/Ulti Firmware updates?