Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Firmware Upgrading Problems > How to upgrade if I only have comfort II logic, UCM/ETH02 and UCM/Zwave? No keypad..
Full Version: How to upgrade if I only have comfort II logic, UCM/ETH02 and UCM/Zwave? No keypad..
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Guest

01-18-2013, 08:06 PM
Hi, recently bought this combination ad the means to control and manage my home zwave network. My configurator is at the latest version of 3.6x and the ucm/eth02 is 6.something which means it can do a direct from pc firmware upgrade of the UCM to 7.008. Problem is I do not have a keypad as it is not necessary for what I need to achieve. The upgrade process prompted for F0 to be pressed. How can I perform the firmware upgrade then?

ident

01-19-2013, 02:04 AM
The workaround is to open Monitor I/O, login and type DA5C01<enter>

Guest

01-19-2013, 03:24 PM
Thanks. It worked!
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Firmware Upgrading Problems > How to upgrade if I only have comfort II logic, UCM/ETH02 and UCM/Zwave? No keypad..