Comfort Automation/ Security System Forums

I have a situation today where my PSTN phone line has deteriorated badly to the stage now where the Phone Trouble Controller status is bad all the time on Comfort.
How can I disable the Phone Trouble Controller for the time being so that Comfort does not keep sending out a warning alarm every so often?

In Comfort tab go to Configuration >> Modules and Settings >> Configuration Flags and check the check-box for \'Ignore Line Cut\'.
Write this change to Comfort afterward.

Any way of replicating this procedure of programming on the keypad itself without the use of the configurator software?

Perhaps you can refer to this post:

http://www.comfortforums.com/forum70/2659.html