The result, now is
I?1801
So, it is ok....... Well, at this point, i don\'t understand where the problem can be.....
Comfort never reports zones or alarms wrong
It should be the homeseer plug in not sending the corect commands or not interpret the results correctly
If there is a monitor mode for Homeseer which can show the messages excahnged between Homeseer and Comfort, use that to check
Going on making some tests, i have a reply asking \"I?2\"
>I?2
<Ok
<NA
Many other inputs reply \"NA\", what does it means?
You need 2 digits
02 not 2
An easier way is to go to zone screen, select the zone and check the status box
This will show you the state
Comfort monitor gives the right results.
You was in right when you said \"Comfort never reports zones or alarms wrong\".....
The problem is not a Comfort problem...... well, now i don\'t know what to do.......
Check with the author of the plug in?
Use ComfortClient?
[user=876]juwi_uk[/user] wrote:
Quote:Use ComfortClient?
yes, and has much better support
Awe you\'re making me blush now.
