Comfort Automation/ Security System Forums

Hi, I\'ve recently been looking into Arduino. My question is would it be possible to get an Arduino to trigger the inputs on Comfort? If so, how would I go about this? (is it as straight forward as a single wire from an Arduino output to a Comfort input?)

Thanks

Bryan.

Yes you can trigger an input of Comfort from an Arduino ouput but take note that the Comfort input accepts 0 to 3 V
Set zone type as Digital N/O or Digital N/C

From recollection, Arduino uses either 3.3v or 5v TTL, so dependant on which board you use, the OP may need some extra circuitry

Vangelis