Comfort Automation/ Security System Forums

In the zone properties, what do \'Show Status\' and \'Module Status\' do?

I cannot find these settings in the documentation.

Thanks.

Show Status, i think, show the status of a zone sensor eg Open / Closed in the Comfigurator Status panel and also on the Smart Phone App

Not so sure on Module Status however...

Vangelis

If you check the \"Show status\" button, the zone status of all zones will be shown on Module Status and any change in zones will be updated
In your screenshot you have Module Status as On, which means zone 6 (Back Door) is Open

There are  also \"Show Status\" buttons for Counters, Flags, Sensors, Outputs which show the status of these registers in Comfort

This is used in Comfigurator only, it does not affect the iphone/ipad app which always shows status

I was confused because it appears that you can enable/disable \'Show Status\' for each zone, when in fact it is a global setting that applies to all zones.

Thanks for explaining. This is a useful feature while I am building my system.