01-30-2014, 10:11 PM
Hi - I have an old Comfort 1 (yes I will upgrade at some point).
I like to tinker with things and have a lot of home automation. I want to experiment with XAP via HomeSeer. I have a Netiom XAP board.
I can wield a soldering iron if I\'m told what I need but have little electronics knowledge.
The output from comfort is 12v, the input to the Netiom board must not exceed 5v.
My question is - what can I put between the two to drop the 12v to 5v and control the Netiom board from Comfort?
Cheers.
I like to tinker with things and have a lot of home automation. I want to experiment with XAP via HomeSeer. I have a Netiom XAP board.
I can wield a soldering iron if I\'m told what I need but have little electronics knowledge.
The output from comfort is 12v, the input to the Netiom board must not exceed 5v.
My question is - what can I put between the two to drop the 12v to 5v and control the Netiom board from Comfort?
Cheers.