Comfort Automation/ Security System Forums

Hello!

As trivial a question as it may seem, but - where from do we download the .knxprod file for the ETS4 KNX programming software? Without it, the ETS4 doesn\'t recognize the UCM/KNX.

Thanks!

The UCM/KNX is not like a KNX device, it is not programmmed by ETS
You program in Comfigurator by mapping the group addresses to Comfort counters, sensors, virtual inputs  and other registers

The UCM/KNX manual will explain in detail. download from https://www.cytech.biz/ucmknx_manual.htm...ory_id=107

OK, so this means that the unit cannot even be defined in the ETS software (so that it is known that there\'s a device with that individual address)?

Thanks!

Correct,  but there is little benefit to be able to see it in KNX from what I can see