Guys I just upgraded firmware from version 6.(something) to latest 7.065 Now it appears that none of my responses are working with RAKO!!
a typical response shown below
RAKO ROOM RAKO 12RAKO CHANNEL RAKO 0RAKO SCENE RAKO 1RAKO ROOM RAKO 13RAKO CHANNEL RAKO 0RAKO SCENE RAKO 1SET LoungLight = 1
Can someone urgently advice me - it is about 30 mins from getting dark and I must have about 50 RAKO responces in the system.
So the off responses still work but not the on ones. I am in the doo doo here - really greatful for any ideas!!
hmmm I notice the sub menu for RAKO is now missing from under the UCM add new action drop down - I am assuming the commands are now no longer built in and I need to add them in the UCM - off to test. This is VERY annoying.
**WIERD** It reappeared.
Guys - can you help please - nothing in my house is bloody working.
So it all works if I programme the actual commands I want into the Commands to the device in the UCM Universal menu. PITA but at least I have figured it out - would have been nice to be warned or some sort of migration - still awesome system though! I had my alarm guy salivating over it earlier when he added a bunch of new sensors into a new flat over the garage. Reckon I have 20 plus of hours of work to go though!
SO I think there is a bug that stops some of the original commands working..... the below works - using scene set in the universal rather than the original command....
\"Rako Room Rako 21
Rako Channel Rako 0
Universal SendCommand Rako Scene:1\"
Add the RAKO command Command ;-) to the bud as well!
Hi :-)
Thanks - yes I noticed it had reappeared.
There is a bug though - the command RAKO SCENE RAKO X does not work now. I had to go through all my code and replace it with code using the Command stored on UCM itself.
