Comfort Automation/ Security System Forums

The date on my system keeps being set to 1 day behind, i can set it correctly via PC/Comfigurator but the eth03/NTP module (i\'m assuming) keeps setting it too day before. I have changed NTP server used and same issue.

I have Comfort II Ultra, ver 7.065
UCM type 10, version 7.061

any idea\'s what might be causing this?

regards

Adrian

Don\'t worry, have seen this is fixed in eth03 2.20

Adrian

There is also a problem reported where during daylight saving each morning, midnight to 1 AM gets set back by 1 hour, but this should not cause ay problem unless you have a time program between 12 and 1 am

http://www.comfortforums.com/forum36/4425.html