Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Zwave > Fibaro Smoke Sensor FGSS-001
Full Version: Fibaro Smoke Sensor FGSS-001
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

MDKKEN

04-18-2016, 07:59 PM
Hi,
I have the wired version of Fibaro Smoke Sensor  FGSS-001 that is wired to comfort.
This device supports Multilevel Sensor V1. I thought \"sensor\" would be available in register type drop down. In mine I only have flag and counter.
I have latest firmware for ZWave and Comfort. Also latest version of configurator 3.11.1.0.
Am I mistaken? I use VERA Edge as the primary controller.


 

yuanchang

04-19-2016, 09:54 AM
Hi MDKKEN,


There are two solutions for this Fibaro Smoke Sensor  FGSS-001\'s usage:
First solution is to include this device into Z-wave network and use the UCM/Zwave learn from the primary controller. After that, map the device with any counter in comfigurator. Under corresponding counter response, program alarm trigger if the counter change to a certain value.
Second solution is to connect the smoke sensor to any input of comfort directly and set the corresponding zone type as \"Fire NC\".
Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Zwave > Fibaro Smoke Sensor FGSS-001