Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Products > UCMs > ETH for Comfort I (Outside 4.132)
Full Version: ETH for Comfort I (Outside 4.132)
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

fil

07-29-2017, 04:48 AM
Hi,
I have an Comfort Outside 4.132 (8001/E) from November 2001 that I would like to get an Ethernet interface into so that I can connect it more fully to HomeAssistant. (I\'m currently doing this via Raspberry Pi GPIO pins via opto-couplers to comfort outputs/zones but would like to do it a bit \"better\" if possible).
I also have KP02, DP01, RDR01 and LEM01-M2
What are the options available?
Thanks

slychiu

07-29-2017, 08:03 AM
The UCM/ETH03 may not work for Comfort 1 which is at least 15 years old
Perhaps you can try buying from another user
The other option is to upgrade to Comfort 2 and buy UCM/ETH03

Your KP02 and LEM01-M2 should be compatible see the module compatibiluty list
http://www.comfortforums.com/forum16/1470.html
Comfort Automation/ Security System Forums > Products > UCMs > ETH for Comfort I (Outside 4.132)