07-14-2018, 08:31 AM
The changes in the beta software are below
Bugs
Bugs
- Read User Codes only visible in Engineer Advanced mode, not in User or Simplified Engineer or EMS modes - Old bug
- Virtual Mode Drag/drop- if a Virtual Input zone is dragged to another zone, the new zone remains virtual but the reference remains at the previous zone number - Old bug
- In User Mode, Control menu with feedback and without actions cannot see feedback - Old bug
- User mode Control Menu press action key works 1 time only - Old bug
- IRIO \"Reset to default\" button does a full read from IRIO
- HIO ââ¬â when show status is checked, Read from HIO causes Unhandled exception
- Copy Counters Action does not cause addressed Counters to be shown as referenced (in blue) - Old bug
- In UCM/GSM4, when copying the text from Comfort for Control Menu, the check for 8 characters maximum for Control Action words is not done. Control Action words are limited to 16 for Alternative Text. Is the SMS any text with more than 8 characters in Control Action words is truncated - Old Bug
- After Scanning for Modules, the latest firmware for HIO, MSM01, TSM01 are shown as \"Unknown\"
- \"If Virtual Input\" condition caused exception
- TSM01 virtual Input when assigned cannot be unassigned, bug only in EMS, not in ULT
- KP04A EMS ââ¬â Prevent changes should be seen in EMS Mode only, not Alarm Mode
- Support for the new MSM01 MultiSensor Module is available
- Scan for Individual Modules has been removed. Only Scan for all modules is available
- Configuration > Voice Settings > Keypad and Phone Announcement Levels Minimum to Maximum Range on the slider have been changed to allow lower volumes for announcements