It seems you may be trying to log in. Do Not Log in
Remember to Short PP2 shunt before trying
Go to Transfer > Firmware Upgrade using UCM Firmware cable
Then select the File
The upgrade will start
double checked all cables and still getting same message. PP2 shunt is in place and i am not logging on. When i right click on the controller and do download firmware upgrade a message appears saying unable to obtain upgrade information.
Siren is going and keypads are beeping as per instructions.
File 7.153 downloaded to PC but still getting message about UCM settings as previous
This is an update on the problem reported.
UCM/ETH02 does not work when upgrading Firmware by right-Clicking on the module and selecting Upgrade. UCM/ETH02 was discontinued many years ago and does not support this newer function. This is why the initial Firmware upgrade did not work.
UCM/Eth02 can only do the upgrade by UCM Firmware Upgrade cable. This method managed to upgrade the ULT Firmware and get the system back to normal
Changed to GSM4(3g) yesterday and working fine will change to ETH03 later today.
Upgraded to ETH03. all went well and unit is getting IP address. When i scan for modules i get the message
---------------------------
Comfigurator
---------------------------
Failed to connect to UCM - please check the UCM Connection Settings
---------------------------
When i go back into the ETH03 it has the IP address and is at current software version.
SORTED. Comfort not set to same IP Address as ETH03. Changed and all working as normal.