Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Comfort 1 to SEM01-M2 and LEM01-M2 compatability
Full Version: Comfort 1 to SEM01-M2 and LEM01-M2 compatability
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

tomekajja

04-05-2007, 06:52 AM

 Hi there,

 I have a comfort 1 with the firmware \"Outside 4.204\". Recently I added

 a LEM01 and then a SEM01-M2. All these are working OK.

 

 My problem is that when I add the LEM01-M2 the comfort does not see

 the zones opening or closing. However when I unplug the Ribbon cable

 connector to the SEM01-M2 the comfort complains saying \"Zone 25

 Trouble….. etc\" . This indicates that the comfort is aware that the

 zones exist but is not seeing the activation of the zones.

 

 Does this mean I need to upgrade the comfort main board firmware or

 entire comfort to a G2 to be able to see these zones.

 

 Please advice.

 

 Regards

 

 TOM
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Comfort 1 to SEM01-M2 and LEM01-M2 compatability