Comfort Automation/ Security System Forums

We did an upgrade to a main CPU a couple of years back using Comfig 3.14.14.0 all went well and its been fine.

I have just re-opened the file using Comfig 3.14.14.0 then gone to alter some settings. When I go to modules tab UCM - module ID 0 appears.

If I open the same file in Comfig 4.0.4.0 there is no ID 0 and the listing is by my reckoning correct.

---------------------------------------------------

We have only used Comfig 4 on new installations.

What should I do in this situation ?

I will be attending site tomorrow to replace a faulty CBUS UCM so will need to know which way o proceed

Thanks

Use Comfigurator 4.0.4 which does not have the ID0 problem. It should not cause any probkems
v3.14.,14 can be used for  very old systems

(06-08-2026, 10:10 AM)slychiu Wrote: [ -> ]Use Comfigurator 4.0.4 which does not have the ID0 problem. It should not cause any probkems
v3.14.,14 can be used for  very old systems

Thanks for swift reply - fingers crossed for tomorrows upgrade.