Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Reset button on Comfort II does not work
Full Version: Reset button on Comfort II does not work
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

ident

07-12-2007, 12:26 PM
The J14 shunt may not be set correctly, based  on whether the MPU01 plug in firmware is installed or not. see http://www.comfortforums.com/view_topic.php?id=303&forum_id=16


This applies only to older Comfort 2 hardware with the MPU01 plug in module
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Reset button on Comfort II does not work