Comfort Automation/ Security System Forums

I have made some config changes over the past 2 days  but nothign that touches any of the night time or sunrise/sunset times.

 

It appears none of the responses are being trigered by the built in sunrise/sunset actions - in the Misc section of comfigurator it just fires off Sunrise and Sunset responses which in turn trigger off CBUS commands. These no longer work.

 

Also, I have responses on external door zones that are triggered, and the first thing they check is the night status - this is no longer working either.

 

So my assumption is the system NightTime trigger has stopped working.

Any ideas why everything has ground to a halt ? Comfigurator shows firmware as 5.113


Update : Just downloaded the November config that was working fine, and that no longer works either - so cant be a CCL issue ?

Im pretty sure this started happening after I uploaded a config on the 29th Dec.

 

Previous config was  21st Dec - which worked ok - and reuploading that config didnt fix it.

 

Would something have gone wrong during an upload ? This is a PITA as none of my night logic works - ie auto lights, etc

 

This has to be due to Sunrise and Sunset times not set to what you expect
Could it be that the Sunrise and Sunset times that you downloaded are not the same as what you expected?
Can you check the ccl file, and also upload (Comfort -> PC) the sunrise./sunset times to check what is in Comfort

The sunrise/sunset times are fine. The ccl has been downloaded a few times - full complete download.

 

ie week 52 is 15:56. Even 6 hrs later, the nighttime flag doesnt work. Ive done an upload - comfort to pc - and they all match.


I\'ve reset the \'location\' to London - which slightly alters the times by a few minutes and done a full download - still doesnt work (its currrently around one hour before sunrise). KP04 shows the time is correct.
 

none of the night time functions worked this morning either. Next step ?

 

FYI -I added this into one of the responses that triggers lights in night mode - the counter value shows as 0 when triggered (watching via wizcomfort monitor)

If  NightTime = 0 Then
    Set Counter242 = 0
Else
    Set Counter242 = 1
End If

Now more of my timers are not activating at all....

Please send the file to support@cytech.biz
Perhaps the same file as the one with timer 31 not working. It may be related

Done

I am glad that we have 1 year to sort it out

Also, the Sunset response started working again today.

 

Consider this a bug report.