Comfort Automation/ Security System Forums
Comfigurator - migrating from V223 to V328 - Printable Version

+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: UCMs (https://www.comfortforums.com/forum-146.html)
+---- Forum: UCM Problems (https://www.comfortforums.com/forum-73.html)
+---- Thread: Comfigurator - migrating from V223 to V328 (/thread-2385.html)

Pages: 1 2

- dcrera - 08-06-2011

Hi

I am migrating from V223 to V328.

How can I successfully import my old .ccl into the new version.

Tried the import option and it dropped off all my responses and settings. The only section that seems to have imported correctly is the Gereral Tab.

Is there a conversion process or a utility to convert ?

Thanks


- ident - 08-06-2011

You can read ccl files created by Comfigurator 2 using Comfigurator 3. In Comfigurator 3, do File Open > select Files of type .ccl
This reads the ccl file. save them as .cclx file type



- dcrera - 08-08-2011

Ok, I used up all my dumb questions for todayBig Grin

- dcrera - 08-12-2011

Hi

I upgraded my firmware on Comfort to 5.218 and my *serial ucm to 6.007

When I try to connect to Comfort i get \'Failed to write to Ucm\' using Comfigurator 3.28

If I use the the newer UCM with the serial sister board with ver 6.007 I get connectivity.

What\'s the buzz ?

Thanks

PS *the serial ucm works with Comfigurator 2.28


- juwi_uk - 08-12-2011

Hi I\'m using one of the older UCM/Serial boards (serial connector and jumper onboard) with 6.007 without any problems.  I\'m using the latest Comfigurator 3.3.1 though.

I guess you\'ve seen that issue that Ingo found in Comfigurator and serial connections if the \"via KT03\" box is ticked.

Julian

 

 


- dcrera - 08-12-2011

Hi

Please send me the url with reference to KT03

Thanks


- dcrera - 08-12-2011

Hi

Loaded Comfig 331

Error \' No response from UCM\' using older UCM with ver 6.007

Help I need somebody


- juwi_uk - 08-12-2011

See this thread at the bottom:

http://www.comfortforums.com/forum20/2382.html

Regards


- dcrera - 08-12-2011

Hi,

Changed to USB and KT03 was unckecked.

Changed back to Serial (no Rs232)

Tried connecting again, same problem \'No response from Ucm\'

When back to newer UCM with sister board ver 6 and I get the came error \'No response from Ucm\'. Going in circles

Thanks


- ident - 08-13-2011

Check shunt SW8-H should be off (Hardware handshake)
SW8- F and G should also be off

If that still happens uninstall and reinstall Comfigurator
There may be some settings left over from the older Comfigurator