RIO Firmware 2.0.0 to 2.0.6 - Printable Version +- Comfort Automation/ Security System Forums (https://www.comfortforums.com) +-- Forum: Products (https://www.comfortforums.com/forum-3.html) +--- Forum: RIO (OBSOLETE - Replaced by IRIO) (https://www.comfortforums.com/forum-84.html) +---- Forum: RIO Firmware (https://www.comfortforums.com/forum-82.html) +---- Thread: RIO Firmware 2.0.0 to 2.0.6 (/thread-1092.html)

- admin - 06-14-2008 [size=2]2.0.6 (Dec 2007) Supports Pulse Output action. Previous versions do not support Pulse Outputs 2.0.4 (March 2007) CBUS2 IR Codes supported, mapped in IRReceive codes 0-31. Adjusted IR Receive algorithm to match new IR Receiver characteristic. 2.02 (May 2005) Fixed Bug in previous versions where noise on an input may cause the RIO to lock up until the input is triggered again 2.0.1 (June 2004) Fixed IR Transmission can transmit IR 0 to 255. Fixed bug could only transmit 0-15 2.0.0 (Dec 2003) - Upgraded processor. Transmit IR 0 to 15 only. IR Transmit buffer increased from 64 to 96 The Firmware history is also documented in the RIO Manual [/size] - segurant - 11-08-2009 The temperature sensor in the SCS I think it is not good solution. Is necessary included an SCS for to access the temperature sensors. An excellent solution I think is the creation of a new RIO (RIO02) with 8 inputs and 8  outputs analog (0 - 10V), so we can place sensors of temperature, light, humidity, etc.. Best Regards Miguel Antunes - ident - 11-08-2009 Lets move this topic to the RIO forum http://www.comfortforums.com/forum84/1669.html