+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: Upgrading from G1 to G2 (/thread-1178.html)
- mikegriff - 09-27-2008
Just about to upgrade from G1 Ultra 4.225
Slave 1 With 4.177 (new)
Slave 2 With 4.177 (as always)
UCMEthernet 5.70 (New) + 256 NVM
UCMAudio 5.70 (New) + 256 NVM
to G2 Ultra
As usual I have bought the kit well over a year ago and am just getting round to it
Am about to order
MPU01 Plug-in Firmware Module
and a couple of UCM05
any advice would be welcome
Thanks in advance
Mike
- slychiu - 09-28-2008
Your G1 Slaves should be Ok with G2 Ultra
It is recommended that you use LEM01-M2 on the Comfort G2, although you may get away with the old G1 LEM01
You will need the UCM05 to do an upgrade on the MPU firmware. Good that you have 2 UCM05s so one can upgrade the other
The Ethernet and Audio plug in modules will work on the new UCM05s, you can even plug in both Audio and Ethernet on one UCM05 if you wish
The Old UCM01s can still be used as serial interfaces to other equipment
I hope you install the new kit soon!