+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Outputs (https://www.comfortforums.com/forum-71.html)
+---- Thread: No Siren or Strobe? (/thread-1274.html)
- tunkselectrical_ryan - 12-22-2008
Hi guys,
anyone have any clues as to why my siren/stobe may not function anymore after a control panel relocation?
Wiring is correct, but there is no noise/light when an alarm is triggered.
Having read a little in the forums, i feel it is something to do with the backup battery. Am i on the right track?
Regards,
Ryan
- admin - 12-23-2008
Relocation of the panel should not have any effect on the siren and strobe outputs
Perhaps the resettable fuse may have activated if there is an overcurrent due to a short circuit on the siren or strobe
Remove the siren and strobe terminal blocks and measure the voltage across the terminals when the alarm is activated. It should be above 12V