+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Arming and Disarming (https://www.comfortforums.com/forum-72.html)
+---- Thread: Autoarm fails.. (/thread-1356.html)
- Manas - 02-16-2009
Hi friends,
I just finished installing MinderPro(comfort) at a residence. I have not given any keypad. Instead, I use 2 NO switches for the control purpose.
The first switch arms system(uses \'Autoarm Security Night\' function). Second switch disarms system along with putting siren off(\'Autoarm Security Off\', \'Siren Off\').
Whenever I program the board or restart it manually, It goes into night mode by pressing 1st switch. Works well.. Gives alarm on zone detection. When I press 2nd switch, siren becomes off and security becomes off.
Now when I press 1st switch to arm security again it fails to do so. I don\'t have keypad so god only knows what error might be occuring...
Please suggest..
I am attaching program for your reference.
Regards,
Manas
- slychiu - 02-17-2009
Not having a keypad is definately not a good idea. You are correct that only God knows what is happening
You can try to find out what happened by checking the Event log. Do TRansfer > Event Log
- Manas - 02-17-2009
I found a link while searching.
http://www.comfortforums.com/forum36/1143.html
The problem resembles to the one at my site. Only difference is that I don\'t have kp.
I will try to upload the Event Log and post reply as early as possible.