+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: Connecting power to main circuit board (/thread-1493.html)
- muddymickey - 06-03-2009
Hi
I am starting my DIY install of Comfort, and have a question regarding connection of power to the main board.
The two wires (both brown) from the mains transformer have a blue connector on the end.
The main board power connection point also has an identical blue connector mounted on the board.
Am I supposed to remove the blue connector from the wires, and connect the wires to the board ?
If so - how do I know which way round to connect them ?
Cheers
Lee
- muddymickey - 06-03-2009
Ahh, I am an idiot.
I just realised the connectors on the board pull off, and the transformer lead pops on in it\'s place.
- slychiu - 06-03-2009
Yes you remove (Unplug) the terminal block on the board and connect the one from the transformer.
Polarity is not important as that is an Ac signal.