+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Responses and Actions (https://www.comfortforums.com/forum-74.html)
+---- Thread: new responde help[ (/thread-1560.html)
- hunters - 08-02-2009
Hi
can somebody help on providing the reponse code for the following
Announce Zone + Switch output 1 (the output is from from the slave expansion panel(REM) 01 this is the one which is currently set to zone numbers 17-24) for 5 minutes latched on
the above will be attached to an on reponse to an external GJD detector which will only activate in the noght during its own internal light sensor
thanks
raj
- TheMax74 - 08-03-2009
If you write this response using response wizard, below the response wizard window you will find the response code, i think. You can write down the code and use it.
- hunters - 08-03-2009
brilliant i will try
thanks