+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: pc connector?! (/thread-1563.html)
- Stereo - 08-08-2009
Hi,
Dont know where is the connector to the pc, someone care to help?
By the way, this is comfort II correct?
here is the photo:
http://yfrog.com/13dscf0312j
Thanks,
Stereo.
- ident - 08-09-2009
The picture shows a Comfort II with a RIO mounted above it
I cannot make out the other small board with a relay, it does not seem to be a Cytech part
To connect to a PC via Rs232 you need a UCM05 shown here
There is also a UCM/USB for USB connection
- Stereo - 08-13-2009
Hi, thank you ident.
Can you give an ideia whats the price of those boards in europe?
One question:
In order to program some makros i always need to use the configurator right?
Thank you once again,
Stereo.
- slychiu - 08-14-2009
I have sent you the contact of a Portugal dealer
You usually use Comfigurator to program Comfort Responses or \"macros\"
Programming by keypad is also possible but more difficult.