+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: Power Failure on Comfort I Ultra (/thread-1583.html)
- Howser - 09-02-2009
Hi All,
On my home system, after each power failure, I have to logon (via the keypad) to clear the power failure led and that creates the power restored event (at logon time). I thought the system should clear this when power is restored, without manual intervention.
Regards
Howser
- slychiu - 09-02-2009
As a security system, Comfort deliberately forces you to acknowledge that there was a power failure.
It may be important that there was not a power failure that occured which you did not know of
- Howser - 09-02-2009
So when will the power restore event run, at signon?
- hendy - 09-02-2009
Howser, if you are referring to the red AC led on the keypad, then yes, the led will be cleared (turned off) when the power is restored.
I have just done a quick test on Comfort I firmware Action 4.233.
What is the firmware that you are having?
- Howser - 09-02-2009
Hi Hendy,
I will check the version when I get home. I am talking about AC Restore Response (Location 1847), is that done as the AC is restored, or at signon ( if signon happens hours after AC restore)?
Regards
Howser
- ident - 09-02-2009
The AC Restore Response runs when the AC is restored