+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: KNX (EIB) (https://www.comfortforums.com/forum-12.html)
+--- Thread: UCM/EIB to UCM/KNX upgrade (/thread-1741.html)
- slychiu - 02-04-2010
For customers who still have the older UCM/EIB which have not been installed, we would like to offer an upgrade to the new more powerful UCM/KNX which will allow you to take advantage of the features including complete monitoring of the alarm conditions mapped to KNX group addresses, and the ability to use a KNX touchscreen to act as a Comfort keypad.
The upgrade is only for UCM/EIB firmware 5.100 and above where the firmware can be upgraded using Comfigurator. The upgrade also involves adding a Nonvolatile memory (EEPROM) to the UCM module.
Please send a PM or email to support@cytech.biz
- koutsogiannis - 02-23-2010
Hi
I activated the tab to send the comfort time and date at KNX, but the LCD screen does not show (NE should reasonably inform a group adress normally 1 to 1 for date and time, what are they from and who defines them?)
- slychiu - 02-23-2010
When there is a completely new question, please start a new Post to ask it so that it will be more meaningful for anyone browsing the forum
This post is regarding the Upgrade of UCM/EIB to UCM/KNX
I have moved the question and reply to http://www.comfortforums.com/view_topic.php?id=1760&forum_id=12&jump_to=6973#p6973 with a topic titled \"How to Send Date and Time to KNX\"