+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: KNX (EIB) (https://www.comfortforums.com/forum-12.html)
+--- Thread: KNX Configurator - WRITE TO EEPROM (/thread-2236.html)
- ident - 04-18-2011
In Comfigurator\'s KNX Configurator. KNX Group Addresses are mapped to Comfort
In the KNX to Comfort Tab, KNX Group addresses are mapped to Comfort Counters, Sensors and other elements
In the Comfort to KNX Tab, Comfort alarm conditions are mapped to KNX group addresses to show the status of the alarm on KNX visualisation screens
After the configuration is done, dont forget to WRITE TO EEPROM. This writes the configuration tables to the UCM/KNX EEPROM (or NVM, nonvolatile memory). If this is not done, the UCM/KNX does not know about the mapping.
Note that Write to Comfort on the Comfigurator Transfer Menu writes the Comfort configuration to Comfort\'s NVM but it does NOT write the KNX configuration to the UCM/KNX.