+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Firmware History (https://www.comfortforums.com/forum-60.html)
+---- Forum: Comfort Firmware (https://www.comfortforums.com/forum-79.html)
+---- Thread: Comfort Firmware 5.214 (/thread-2255.html)
- slychiu - 05-07-2011
Bugs Fixed
- Fixed BUG when GSM dial in and there is a greeting message in the system, the Comfort voice is not heard.
- Fixed Bug - Offhook Response is wrongly activated after recording via UCM/GSM and the a keypad sign in causes the call to be ended while recording.
- Fixed BUG - Tuning parameter Master dtmf gain only 0 to 7 was valid , > 8 was invalid
- Say Words action allow 255 to terminate words list but not the whole response
- Alternate Siren output port on the CPU does not turn on at reset. This requires modified Comfort PCB.
- F8 Intercom When receiver press 0 to talk then originator press 0, it cannot talk.
- Comfort does not send siren parameters to slave for non-alternating tones
- Slave Strobe does not work
- TheMax74 - 05-11-2011
Siren Output
Alternate Siren output port on the CPU does not turn on at reset. This requires modified Comfort PCB.
Can you explain \"This requires modified Comfort PCB\", please?
Thanks.
- slychiu - 05-11-2011
You may know that when Comfort is powered on the siren sounds for a few seconds.
There will be a hardware modification on new Comfort PCBs in which the Siren output will not turn on when Comfort is powered on. This firmware caters for both modified and unmodified hardware. In the unmodified hardware (ie what you have now) the siren will still turn on at power on.
- Ingo - 05-11-2011
Would this be for the flashing strobe also?
Can the modification be done by a user or would it be \'factory only\' type mods?
Are the two different options selectable in software? If I make the modification and the client later changes his mind and want it back on, can it be done?
Ingo
- slychiu - 05-12-2011
No. This change is for the Siren only. The stobbe flashing at when the power is turned is not as bothersome as the siren. The modification is best done in the factory as an incorrect modification may cause a fault