+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Questions on Installation and Connection (https://www.comfortforums.com/forum-123.html)
+--- Thread: Vortex Bell Box wirring (/thread-2501.html)
- Swiss-Toni - 10-07-2011
Hi (forgive me im a newby on a sharp learning curve) Does anyone know how to match up the Vortex bell box wiring to the comfort Ultra panel The Siren and strobe work fine, however Im at a loss as to the tamper.
Bell Box Config as follows:
Hold+ Hold- TG STB- Return
This is the set up so far:
Bell box Comfort Ultra
Hold+ SRN+
Hold- ????
TG SRN-
STB- STR-
Return ????
Hold- I think should go to Com (but which one)
Return, is bell tamper return but to where.
Any help would be appreciated
Last edited on Friday Oct 7th, 2011 09:53 pm by Swiss-Toni
- slychiu - 10-08-2011
The correct connections should be as below
Bell box Comfort Ultra
Hold+ SRN+ (Siren +ve supply)
Hold- COM (Tamper COM or COM on 12V)
TG SRN- (Siren -ve trigger)
STB- STR- (Strobe -ve trigger)
Return TAMP (Tamper Terminal)
- juwi_uk - 10-08-2011
Swiss, remember...it\'ll be as easy as making love to a beautiful women.....!
[..But lost on those who never saw the Fast Show!]
- Swiss-Toni - 10-09-2011
One of the few who remember it
