+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: KNX (EIB) (https://www.comfortforums.com/forum-12.html)
+---- Forum: KNX Support (https://www.comfortforums.com/forum-112.html)
+---- Thread: 1 bit Arm to Away group address seems not working (/thread-2586.html)
- TheMax74 - 11-10-2011
Map 1 bit Arm to Away to a group address seems not working.
Sending \"1\" from KNX bus to this group, does nothing in Comfort.
Can you check please?
Thanks.
- slychiu - 11-11-2011
This is the most commonly used function for KNX which should definately work
Can you send your cclx file to support@cytech.biz
- TheMax74 - 11-11-2011
No, thanks, i will investigate more.
Shure is my mistake.
Thank you.
- Canha - 11-15-2011
Try updating the firmeware...it worked for me..
- TheMax74 - 11-15-2011
Thanks
- Tan121 - 11-21-2011
I seem to have the same problem after updating the firmware. Before it worked fine. Now I have all the modules last firmware and Comfort is sending time to KNX but Night Arming from KNX does not work.
- ident - 11-22-2011
Did you WRITE to EEPROM for the UCM/KNX?
- ident - 11-24-2011
We have confirmed that there is a bug in Comfort firmware 6.006, which causes the 1-bit arm from KNX not to work, see http://www.comfortforums.com/forum79/2571.html
Please downgrade to ULT 6.005 for the time being
We are working on a new firmware release to fix this problem
- TheMax74 - 11-24-2011
Thanks.
- ident - 12-10-2011
We have found and fixed the bug in Comfort which causes the 1-bit arming not to work. Now we are doing intensive testing of the firmware which will take some time
The firmware ULT 6.009 is attached for those who would like to try it out for themselves before the release
See forum for Ultra beta firmware 6.009 http://www.comfortforums.com/forum79/2637.html