![]() |
|
Battery warning - Printable Version +- Comfort Automation/ Security System Forums (https://www.comfortforums.com) +-- Forum: Support (https://www.comfortforums.com/forum-2.html) +--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html) +---- Forum: Troubles (https://www.comfortforums.com/forum-77.html) +---- Thread: Battery warning (/thread-2787.html) Pages:
1
2
|
- rogermac - 03-21-2012 My comfort (10 years old)has decided to dial out at 3am every morning to the mobile numbers programmed into it with the message \"battery warning\" 5 times to each of the 3 programmed numbers is there a glasgow installer who can help or is it a simple battery replace? thanks - ident - 03-21-2012 The Battery needs to be replaced. 10 years is over the life of a typical battery Comfort tests the battery every 24 hours and if it finds the battery is weak it causes a Battery Warning Alarm. So your Comfort has been testing your battery for 10 years. You could disable the dial out for the Battery Warning alarm though as a local notification should be enough You need a sealed Lead acid battery 12V 7 Amp Hours. It is the black rectangular slab you see when you open the case (be careful of triggering a Tanper alarm when you do so - rogermac - 03-21-2012 many thanks for that info how do i disable the tamper switch? if the alarm is not armed is it ok to open the unit? regards - ident - 03-21-2012 enter your code and pres 3,4,2 for Security Check. This prevents alarms from activating while you test the system - rogermac - 03-21-2012 mant thanks - rogermac - 03-26-2012 changed the battery today ....no problem but i could not turn off the tamper alarm! i entered my security code then 342 then # and it still went off....tried security code then # then 342 still went off.? what am i doing wrong? hopefully wont need to do it again for another 10 years! - ident - 03-26-2012 Enter your code then 3 for Security Menu, 4 for Test and 2 for security Check. Dont press # as this will go to the previous menu Voice should say \"Security Check\" to show it is in that mode - wiredhome - 03-26-2012 The recommended life of a battery is about 5 years, this maybe shorter if the panel in in a very hot room 20deg c I woulsd highly recomment replacing the battery every 4 years - rogermac - 03-26-2012 ok many thanks - davids - 07-16-2012 I have plugged in a new battery and when I have tested it through the test function of the Engineer Menu the battery check still fails. The new battery has been plugged in now for a few days and I would have thought it would be now charged up fully. What else could be wrong? |