+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: KNX (EIB) (https://www.comfortforums.com/forum-12.html)
+---- Forum: KNX Support (https://www.comfortforums.com/forum-112.html)
+---- Thread: UCM/KNX Monitor Mode (/thread-2788.html)
- Tan121 - 03-21-2012
I am using Comfort II 6.011 and UCM/KNX.
If I look at the Monitor Mode in Comfigurator I see KNX traffic, but Comfort does not send/receive any commands.
As soon I switch away from Monitor Mode (to \"KNX to Comfort\" for example) then communication works fine again.
Have you had the same problem?
- ident - 03-22-2012
Monitor Mode is for looking at received KNX telegrams only and normal operation is not supposed to work You have to exit moniotr mode for the receive telegrams to work
- ident - 02-18-2013
Please note a potential problem with monitor Mode in this post
http://www.comfortforums.com/view_topic.php?id=3286&forum_id=112&jump_to=14097#p14097
- juwi_uk - 02-18-2013
That link doesn\'t work IDENT.
Thanks it has been fixed IDENT