+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Firmware Upgrading Problems (https://www.comfortforums.com/forum-111.html)
+---- Thread: Firmeware update (/thread-2795.html)
- Canha - 03-27-2012
Hi
I have a UCM/Eth and a UCM/RS232. I want to upgrade the firmeware of both UCM but I have two problems.
The UCM/Eht has a 5.192 firmeware and th UCM/RS232 has 5.128. I can\'t upgrade the UCM/Eht because the firmeware of the UCM/RS232 is too old. When I do the \"Scan for all modules\" with only these two modules, this is what is shown (picture below). It show\'s that the UCM/RS232 is a CWM. Is this possible?
Now, I can\'t upgrade the UCM/Eth because I can\'t upgrade the UCM/RS232.
Any ideas?
Thanks
Avelino Canha
- ident - 03-28-2012
That is strange
I will contact you by Private mail to give instructions
- ident - 03-28-2012
Actually I think you can use UCM/ETH 5.192 to upgrade the firmware of UCM 5.128 to the latest UCM 6.012 using the programming cable as shown in http://comfortforums.com/forum4/1782.html
can you give it a try?
- Canha - 03-28-2012
Yes, i\'ve alredy tried this way. I can\'t use the other two ways because the UCM/Eth is not 6.xxx.
I\'ve upgraded two other UCM\'s (UCM/KNX and UCM/GSM2) and it worked fine.
- ident - 03-29-2012
What message did you get when you tried using the UCM/Ethernet to upgrade UCM/232 to a new version?
- Canha - 04-10-2012
Hi
The message that I get is shown below.
- Canha - 04-10-2012
When I scan the modules:
- ident - 04-10-2012
Instructions have been sent by private message. Please check
- Canha - 04-10-2012
Check
I\'ll try and then reply.
Thanks