+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Outputs (https://www.comfortforums.com/forum-71.html)
+---- Thread: LEM01 (/thread-2832.html)
- brianza - 04-15-2012
I have a LEM01 connected to an ULTRAII.
All my 16 Zones work well but today I needed to use Output 9 and this did not work. I actually have 16 outputs in total (and am using 4 relay units).
I know that outputs 9 onwards are not working as I cannot hear the relay click when activated. On the other hand Relays connected to outputs 1-8 (that is those directly on the UltraII board) work just fine.
Besides connecting the ribbon cable is there anything else that I needed to do to enable the outputs 9-16?
rgs
Brian
- ident - 04-16-2012
There is no setting required to enable the Outputs on the LEM
If the Outputs 1 to 8 work, try exchanging the OP1 betweeen the LEM and Comfort
Switch off power and battery to Comfort before unplugging the OP1s
