Comfigurator - Printable Version +- Comfort Automation/ Security System Forums (https://www.comfortforums.com) +-- Forum: Support (https://www.comfortforums.com/forum-2.html) +--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html) +---- Forum: Responses and Actions (https://www.comfortforums.com/forum-74.html) +---- Thread: Comfigurator (/thread-3629.html)

- juwi_uk - 11-30-2013 Hi What rules determine whether this message below is displayed (tried both 3.7.6 & 3.7.7) when you try to execute a response. Even though I\'ve saved all config back to Comfort and reset it STILL keeps asking me this question. Getting pretty fed up of this check now! Julian - ident - 12-03-2013 The conditions are When the Response has more than 24 bytes, it needs to use R! command rather than DA commands to execute the response The current configuration has changed since the current Comfigurator session started or the complete configuration was written to Comfort within the current session. The 2nd rule means that if you made a change to the configuration during the session, it will ask to write responses again even though you have already done it That probably needs to be changed so that it should not ask if the configuration has not changed since the last write - juwi_uk - 12-03-2013 So this is a bug? I couldn\'t find a way around it even though I\'d just done a full write to comfort and immediately then pressed the execute button on the response. Julian - ident - 12-03-2013 Yes it is a bug The simplest workaround is to just answer No to the question, the response will be executed, if you are sure you  have not made any changes to the response Or If you load the cclx file and execute response it will not give the message